A 2015 Mazda 6 with a 2.2 SKYACTIV-D engine arrived with a persistent P1336 correlation code that returned immediately after clearing at idle. The fuel rail and boost pressures matched commanded values perfectly, but the timing synchronization fault refused to clear. Freeze frame data showed an engine speed of 799 rpm, a coolant temperature of 45 degrees Celsius, and a system voltage of 14.38 V. The issue was not intermittent, pointing to a hard mechanical offset or an outright sensor failure.
The 10.45 Degree Limit on the Timing Chain
Our diagnostic platform ranks timing chain elongation as the most probable cause for a P1336 code on the SH engine. The powertrain control module (PCM) continuously monitors the angular difference between the crankshaft (CKP) and camshaft (CMP) reference pulses. This is visible in live data under the parameter CC_DIFP_WOA, which stands for Crankshaft-Camshaft Difference Phase Without Adaptation.
Normal values for a healthy chain are between 0 and 7 degrees. Mazda software sets a critical threshold at 10.45 degrees of crankshaft rotation. Once this angle is met or exceeded due to cumulative wear on the chain links and guide rails, the PCM determines the chain has reached its maximum allowable stretch. The system will set the P1336 code immediately, even at an idle speed of 799 rpm.
Temperature Blocks the Calibration Procedure
Sometimes a workshop replaces the chain but the fault remains active. The PCM relies on a Timing Chain Correction adaptation register to verify timing. If the chain was recently replaced, or if the PCM reset was incomplete due to a battery disconnect, the system compares real timing against an outdated map.
Crucially, the freeze frame data for this Mazda showed an engine idling at 45 degrees Celsius. The SKYACTIV-D software refuses the chain calibration procedure if the engine coolant temperature is below 65 degrees Celsius. Attempting a reset cold leaves the learning incomplete and the P1336 active as a persistent learning error.
Sensor Delays and Magnetic Debris
The code explicitly flags a correlation issue, which can also stem from signal degradation. A failing Hall effect camshaft position sensor can develop increased internal resistance. This causes a switching delay in the millisecond range. At 799 rpm, this electrical delay is interpreted by the PCM as a mechanical phase shift between the shafts.
Similarly, internal engine wear can produce fine ferromagnetic debris in the oil. This metallic paste collects on the magnetic pickup of the CKP or CMP sensors, distorting the magnetic field generated by the reluctor wheel. This alters the effective air gap, delaying the switching threshold and tricking the PCM into seeing a synchronization error.
Where to Start the Diagnosis
Start by viewing the CC_DIFP_WOA live data parameter before picking up any tools. If the value reads 10.45 degrees or higher, the timing chain requires mechanical verification with locking pins. If the chain was already replaced, check the engine coolant temperature to ensure it is above 65 degrees Celsius before attempting the adaptation reset. Only after ruling out chain stretch and calibration failure should you pull the sensors to inspect for metal shavings or scope the CMP signal for delayed switching.