Subaru fault codes

13 distinct codes across 9 real diagnostics on Subaru, including the Subaru-specific ones no generic code list can decode.

Subaru-specific codes

These are manufacturer-specific, which means the same code on another marque is a different fault. That is exactly why they have no page of their own here and no entry in any generic code list: a single description for one of these would be wrong more often than right. Below they are scoped to Subaru, ranked by how often we have actually seen them, which is a claim we can stand behind.

Code Diagnostics on Subaru
P1380 1
P1468 1
P1603 1

To turn one of these into a cause you need the marque, the model and the engine, which is what the tool does. A code on its own is a starting point, not an answer.

Standard codes we see most on Subaru

These are standardised, so they mean the same thing on every vehicle and each one has a page of its own. The counts are what we see on Subaru specifically.

Code What it is On Subaru
P2463 Diesel particulate filter restriction, soot accumulation 2
P246C Not individually documented 2
P2762 Torque converter clutch pressure control solenoid circuit range/performance 2
P000A A camshaft position slow response, bank 1 1
P000B B camshaft position slow response, bank 1 1
P0017 Crankshaft/camshaft position correlation, bank 1 sensor B 1
P0102 Mass or volume air flow circuit low input 1
P0300 Random or multiple cylinder misfire detected 1
P0420 Catalyst system efficiency below threshold, bank 1 1
P2002 Diesel particulate filter efficiency below threshold, bank 1 1

What tends to go wrong on Subaru

By share of the codes we have seen on this marque. A description of our own caseload, not a reliability ranking.

  • Diesel particulate filter · 3
  • Powertrain, manufacturer-specific · 3
  • Not yet classified · 2
  • Transmission · 2
  • Fuel pressure and delivery · 2
  • Air intake and MAF/MAP · 1

Real cases

Real Subaru cases

Single diagnoses on this make, written up: the car, the codes, the causes ranked and what to check first.

FAQ

Frequently asked questions

How do I run a diagnosis?

Select the vehicle on Start, click the Diagnostic card and choose New diagnostic. Fill in the description, the error codes and the mileage, then click Analyze.

Copy link
Do I have to type the codes from my scan tool?

No. Click the camera button next to Error codes and take or choose a photo of the scan tool's screen; WrenchLane reads the codes and their descriptions into the form. You can also speak them with the microphone.

Copy link
Are the public fault code pages built from my diagnostics?

They use diagnostics run in WrenchLane, with no workshop, customer, registration number or VIN shown. Each fault code page shows how often the code was seen and in how many workshops.

Copy link

Decode a Subaru code against the actual car

Enter the code, the model and the symptoms and get ranked probable causes for that specific vehicle, with the checks in the order worth doing them.