Networks & control modules Engine & misfires

Diagnosing P064C00 on a Skoda Superb 2.0 TDI

Explore a complete diagnostic path for resolving a P064C00 glow plug control module fault code on a 2017 Skoda Superb III 2.0 TDI DFHA engine.

P064C

2017 Skoda Superb III (3V)

In this article

A 2017 Skoda Superb III 2.0 TDI arrived with a dashboard warning light and a single P064C00 fault code stored in the engine control unit. The vehicle, running the DFHA engine on the MQB platform, required a methodical approach to isolate whether the failure was internal to the module, a wiring issue, or a downstream component overload.

Internal Failure of the J179 Module

Our diagnostic platform ranked an internal failure of the glow plug control module at a 75 percent probability. This solid-state PWM relay, designated J179 and often marked as relay 527 (VAG part 04L 907 282 B), runs a continuous self-diagnostic test during the first seconds of ignition.

Repeated thermal cycling and high operating amperage eventually degrade the internal power MOSFETs, the logic control stage, or the solder joints on the circuit board. When this happens, the engine control unit logs P064C00. Verification requires running an output test for the J179 relay via the diagnostic tool, monitoring the activation signal and working voltage in real time, and measuring the PWM output on each channel during the pre-heating phase.

Socket Contact and Power Supply Drops

Ranked second at 45 percent is oxidation or pin fretting in the module socket. The distribution box in the engine compartment is exposed to constant vibration and condensation. A resistance increase of just 0.5 to 1.5 ohms on the power or signal pins causes variable voltage drops that trigger the same performance error.

A direct DC line from the battery, protected by a 50A or 60A fuse on the E-Box, powers the module. Thermal fatigue can cause micro-cracks in this fuse. If the retaining nut is loose, or if the ground path has high resistance, the voltage crashes the moment the module attempts to supply current to the glow plugs. Technicians should perform a pin drag test, measure the voltage drop under load across the B+ and ground pins, and verify the ground resistance to the negative battery terminal remains under 0.2 ohms.

Module Overload from a Failing Glow Plug

At a 30 percent probability, a failing glow plug is the root cause. The J179 module measures the current drawn by each glow plug in real time. If a plug develops a partial internal short dropping its resistance below 0.2 ohms, or fails open completely, the severe load imbalance trips the module's safety shutdown.

This protective action prompts the module to send the P064C00 message to the ECU before it can isolate the specific channel and log a cylinder-specific code between P0671 and P0674.

Diagnostic Starting Point

Begin by measuring the cold resistance of each individual glow plug with the connector unplugged. Because a shorted glow plug will overload the circuit and trigger a generic performance fault, replacing the control module without checking the plugs risks instantly damaging the new unit. If the glow plugs test within specification, inspect the 50A or 60A E-Box fuse for micro-cracks and test the socket connections before condemning the J179 module.

Reference pages for the codes in this article

  • P0671: what we measure for this code across real diagnostics
  • P0674: what we measure for this code across real diagnostics

Start diagnosing with confidence today

Try WrenchLane and see how much time you can save, from diagnosis to repair.