P2763: Torque converter clutch pressure control solenoid circuit high
What the code tells you on its own
- System
- Powertrain
- Functional group
- Transmission
- Subsystem
- Transmission and drivetrain
- Failure type byte, when the tool sends one
- 15 (Circuit short to battery or open)
Engine, fuel, air, ignition, emissions and transmission. The overwhelming majority of what workshops bring to the AI.
Scan tools report the same fault as P2763 and as P2763xx, where xx is a sub-type. They are one fault, and whether the sub-type appears at all depends on the tool and the protocol rather than on the car.
What we see when P2763 turns up
Measured across the diagnostics run through Wrenchlane, not taken from a reference table. Figures as of 2026-10-06.
- Diagnostics
- 1
- Separate workshops
- 1
- Arrived code only
- 0%
- Most common marque
- Land Rover
April 2026
Seen at a single shop so far
No symptom description entered at all
Where we have seen it most
These are counts from our own work, not a claim about how common the fault is across all vehicles. They describe what independent workshops brought to us, which is a narrower and more specific thing.
Run P2763 against the car in front of you
Enter the code and the symptoms and get ranked probable causes for that specific vehicle, with the checks in the order worth doing them. Free account, no card.
Start freeOther transmission codes
- P0700 Transmission control system, MIL request
- P0751 Shift solenoid A performance or stuck off
- P0715 Input or turbine speed sensor A circuit
- P0830 Clutch pedal switch A circuit
- P0741 Torque converter clutch circuit performance or stuck off
- P0743 Torque converter clutch circuit electrical
- P2762 Torque converter clutch pressure control solenoid circuit range/performance
- P0720 Output speed sensor circuit
FAQ
Frequently asked questions
How do I run a diagnosis?
Select the vehicle on Start, click the Diagnostic card and choose New diagnostic. Fill in the description, the error codes and the mileage, then click Analyze.
Learn more: Diagnostic (vehicle-first start), Diagnostic form: description, error codes and mileage
Do I have to type the codes from my scan tool?
No. Click the camera button next to Error codes and take or choose a photo (JPEG or PNG) of the scan tool's screen; WrenchLane reads the codes and their descriptions into the form. You can also speak them with the microphone.
Learn more: OBD reader photo scan (fault codes from a photo), Voice input for the problem description
Are the public fault code pages built from my diagnostics?
They are built from anonymised, aggregated diagnostics run in WrenchLane; no workshop, customer or vehicle can be identified. Each fault code page shows how often the code was seen across those diagnostics and in how many separate workshops.
Learn more: Fault code pages on wrenchlane.com (fault-code cluster)