P0100: Mass or volume air flow circuit

What the code tells you on its own

System
Powertrain

Engine, fuel, air, ignition, emissions and transmission. The overwhelming majority of what workshops bring to the AI.

Functional group
Air intake and MAF/MAP
Subsystem
Fuel and air metering

Diagnostics

What we see when P0100 turns up

Measured across the diagnostics run through Wrenchlane, not taken from a reference table. Figures as of 2026-10-06.

Diagnostics
12

March 2026 to September 2026

Separate workshops
11

Not one shop meeting it repeatedly

Arrived code only
58%

No symptom description entered at all

Most common marque
Ford

Where we have seen it most

These are counts from our own work, not a claim about how common the fault is across all vehicles. They describe what independent workshops brought to us, which is a narrower and more specific thing.

Our diagnosis data

What WrenchLane ranked first on P0100

Across 16 real diagnoses of P0100 from 16 workshops (February 2026 to November 2026), this is the cause WrenchLane ranked most likely for the code, grouped by the part it named. Most often: Mass air flow (MAF) sensor, in 88% of them.

  1. Mass air flow (MAF) sensor 88% (14 of 16)
  2. Wiring, connector or ground fault 13% (2 of 16)

Makes we see it on most: Ford 4 · Volvo 3 (of 16)

How to read this: these are the causes WrenchLane ranked first from the codes, the car and what the mechanic entered, not confirmed repairs. Each diagnosis is anonymised: no workshop, customer or number plate is used. Our own test accounts, the demo car and repeat runs of the same car are left out. We only publish a figure that rests on at least 10 diagnoses from at least 3 different workshops, with no single workshop above half of them; a code listed alongside needs at least 3. It describes what independent workshops brought to us, not how common a fault is across all cars. Data as of 2026-11-17. How we use diagnosis data

Real cases

Real cases with P0100

Diagnoses of P0100 on real cars, written up: the car, the codes it came in with, the causes ranked and what to check first.

FAQ

Frequently asked questions

How do I run a diagnosis?

Select the vehicle on Start, click the Diagnostic card and choose New diagnostic. Fill in the description, the error codes and the mileage, then click Analyze.

Copy link
Do I have to type the codes from my scan tool?

No. Click the camera button next to Error codes and take or choose a photo of the scan tool's screen; WrenchLane reads the codes and their descriptions into the form. You can also speak them with the microphone.

Copy link
Are the public fault code pages built from my diagnostics?

They use diagnostics run in WrenchLane, with no workshop, customer, registration number or VIN shown. Each fault code page shows how often the code was seen and in how many workshops.

Copy link

Run P0100 against the car in front of you

Enter the code and the symptoms and get ranked probable causes for that specific vehicle, with the checks in the order worth doing them.