Body, airbags & comfort Networks & control modules

Diagnosing a Volvo V60 II with Multiple SRS and DSTC Fault Codes

Diagnosing a 2013 Volvo V60 II with codes U015100, B10A202, B10A206, and B10A215. Learn how SRS power loss and CEM moisture trigger DSTC warnings.

U0151 · B10A2

2013 Volvo V60 II

In this article

A 2013 Volvo V60 II arrived in the bay with an illuminated red airbag light, a yellow DSTC warning, and four communication fault codes, despite the vehicle driving perfectly. The customer reported that the car drove normally but displayed warnings stating "DSTC Serv erfordras", "on call erfordras", and "SRS airbag service snarast". A scan revealed four codes: U015100, B10A202, B10A206, and B10A215.

Power Loss to the Restraint Control Module

Our diagnostic platform ranked a voltage or ground drop to the SRS module (RCM) as the most likely cause, at 78 percent probability. The module sits under the center console and requires continuous and ignition-switched 12V power from the Central Electronic Module (CEM), plus a solid ground to the transmission tunnel. If the module loses power, it stops all CAN bus communication. This triggers the U015100 code across the CEM, BCM, and DIM.

Simultaneously, the hardwired crash input signal line between the SRS and CEM drops out. The CEM monitors this line continuously and logs B10A215 (circuit short to battery or open), B10A202, and B10A206 when the signal vanishes. Because the DSTC and Volvo On Call systems rely on this crash status for stability control and emergency dialing, they enter a reduced state and illuminate their warning lights. The first diagnostic step is measuring voltage under load at the SRS connector and checking the chassis ground resistance.

Internal Module Failure

The second most likely cause, ranked at 72 percent, is an internal hardware failure within the SRS module itself. Thermal stress can cause solder joint fatigue, a failed internal voltage regulator, or a dead CAN transceiver. When this happens, the module fails to broadcast on the high-speed CAN network and stops generating the analog crash signal.

The resulting code cascade is identical to a power loss. To differentiate between the two, technicians should use a factory tool like VIDA for network identification. It is vital to verify power, ground, and bus signals directly at the module pins before condemning the hardware.

Wiring Damage and Moisture Ingress

A localized wiring fault on the crash input line ranked at 55 percent probability. If this specific wire suffers a break, chafes against console brackets, or shorts out, the CEM will log the same B10A-series codes. If the damage also affects adjacent CAN lines, U015100 will appear. Technicians should perform a continuity and insulation test on the crash signal line.

We also track a 42 percent probability of moisture ingress at the CEM. On this Volvo platform, water can leak from a windshield or clogged sunroof drain, running down the A-pillar and dripping onto the CEM under the passenger glovebox. Corrosion between the crash input pins and adjacent power terminals will trigger the internal fault logic. A visual inspection for green oxidation on the CEM connectors is required.

Diagnostic Takeaway

When troubleshooting a total loss of crash data on this platform, start by verifying power and ground to the SRS module under load. A dead module will cascade faults into the anti-slip and telematics systems. Confirming the integrity of the module's supply voltage prevents the unnecessary replacement of expensive network nodes.

Reference pages for the codes in this article

  • U0151: what we measure for this code across real diagnostics

Start diagnosing with confidence today

Try WrenchLane and see how much time you can save, from diagnosis to repair.