Body, airbags & comfort Networks & control modules

Diagnosing Heater Faults B1D3194 and U132E87 on a V90

A diagnostic guide for a 2020 Volvo V90 II presenting with fuel heater failure, focusing on codes B1D3194, U132E87, and U133C87 and CPM communication.

B1D31 · U132E +1

2020 Volvo V90 II

In this article

A 2020 Volvo V90 II rolled in with a dead fuel heater and a mix of codes, including B1D3194 for an active flame before the start sequence even began. The technician noted the fuel heater was completely inoperative. When the diagnostic platform analyzed this alongside U132E87 and U133C87, it pointed to a cascading issue where physical sensor failures and communication drops overlap.

The Primary Culprit Behind B1D3194

Our data ranked a defective flame sensor or a short circuit in the combustion heater control module (CPM) circuit as the highest probability, at 85 percent. Code B1D3194 indicates the CPM is reading an active flame or excessive temperature in the combustion chamber during the aftercooling phase or before a start sequence begins.

On modern fuel heaters, the flame sensor is a temperature-sensitive resistance sensor or is integrated into the glow plug monitoring circuit. If the sensor suffers internal degradation or the wiring shorts to ground, the signal voltage drops below 2.5 volts. The CPM interprets this as an uncontrolled burn and immediately cuts off the fuel supply for safety. To verify this, the technician must measure the resistance of the flame sensor and glow plug while the unit is cold, and check the signal voltage via real-time data.

PHEV Drive Cycles and Soot Buildup

Ranked closely at 78 percent was severe coking and soot buildup in the combustion chamber and glow screen. Vehicles driven primarily on short electric or hybrid trips frequently abort heater cycles before the combustion chamber reaches full operating temperature. Without a complete burn-off phase, soot accumulates rapidly.

This soot can form an electrically conductive bridge across the flame sensor electrodes, or glowing flakes can keep the chamber abnormally hot long after shutdown. Both scenarios trigger the B1D3194 code. The recommended procedure is a physical teardown to inspect the combustion chamber and glow screen, looking specifically for soot bridging the sensor tip.

Communication Drops and the Wheel Well Environment

The presence of U132E87 and U133C87 required looking beyond the heater unit itself. Code U132E87 occurs when the central electronic module or climate control module loses bus communication with the CPM. The CPM is mounted in the right front wheel well, exposing it to road salt, water, and rapid temperature changes. A blown main 12V fuse, caused by a short in the heater, or moisture intrusion at the connector pins will cut power or bus signals.

Simultaneously, U133C87 indicates the climate control module has lost LIN bus communication with the front cabin fan motor. The climate system requires a functioning cabin fan to defrost windows and distribute heat. If the fan communication drops, the climate module will block or abort the preheating request entirely.

Where to Begin Testing

For a vehicle presenting this exact combination of codes, the diagnosis must start with the power and communication infrastructure. Verify the 12V main supply and ground at the CPM connector in the wheel well, inspecting the pins closely for moisture and oxidation. Once power and communication to the CPM and the cabin fan are confirmed, move on to checking the flame sensor resistance and dismantling the heater core to inspect for conductive soot bridges.

Start diagnosing with confidence today

Try WrenchLane and see how much time you can save, from diagnosis to repair.