Emissions & exhaust

Diagnosing AdBlue Injector Codes P202EFC and P2EAEFB on a Mercedes Sprinter

Learn how to troubleshoot simultaneous AdBlue injector codes P202EFC and P2EAEFB on a 2020 Mercedes Sprinter OM654 engine using a structured diagnostic path.

P3006 · P3007 +2

2020 Mercedes-Benz Sprinter (907/910) III

In this article

A 2020 Mercedes Sprinter arrived with an AdBlue warning on the dash and five fault codes, including P202EFC and P2EAEFB for both the engine-mounted and underbody dosing valves. When a twin-dosing SCR system throws circuit codes for both injectors at once, the diagnostic path requires isolating the components from the shared harness.

Diagnosing the engine-mounted injector

Code P202EFC indicates an electrical or signal deviation for the first reducing agent injector. The OM654 engine utilizes a Gen4 SCR system with a twin-dosing setup. Injector 1 sits directly after the DPF on the exhaust elbow. This location subjects the component to extreme thermal stress and engine vibration.

The control module (N118/5) flags this code when the solenoid coil resistance falls out of specification. This immediately initiates the regulatory start block sequence, logging codes P300664 and P300702. The best initial test is a direct resistance measurement of the solenoid coil, followed by checking the pulse width modulation (PWM) signal under load.

Evaluating the underbody injector circuit

Code P2EAEFB points to a signal or circuit failure for the second reducing agent injector. This valve is mounted on the exhaust pipe under the vehicle, just before the underbody catalytic converter.

The chassis placement leaves it highly exposed to road salt, moisture intrusion, and mechanical impacts. These environmental factors frequently cause internal short circuits or broken coils. Verifying this failure requires an actuator test through the diagnostic tool, combined with testing voltage and ground at the two-pin connector during activation.

Shared harness and module vulnerabilities

Seeing circuit codes for both dosing valves simultaneously raises a red flag for the wiring harness. Both injectors receive power and control from the N118/5 SCR module. The harness runs along the frame rails and near hot exhaust components.

Chafing against sharp chassis edges or thermal damage can easily short out both circuits. If the wiring proves sound, the diagnostic focus shifts to the N118/5 control unit itself. Moisture ingress or a previous voltage spike can burn out the internal MOSFET drivers that ground the injectors.

Isolating the root cause

When faced with simultaneous circuit codes for both SCR injectors on an OM654 engine, start by visually inspecting the shared wiring harness along the frame rails. A load test on the wiring with a test light will quickly reveal any broken strands. If the harness is intact, check the resistance directly at the pins of both the engine-mounted and underbody injectors before condemning the SCR control module.

Start diagnosing with confidence today

Try WrenchLane and see how much time you can save, from diagnosis to repair.