A 2019 Mercedes-Benz GLE (V167) arrived at the workshop with the yellow check engine light illuminated, yet the vehicle drove perfectly fine. A quick scan revealed a single fault code, P00DF28, pointing to an abnormal signal offset in the intercooler coolant temperature sensor circuit.
Thermal drift in the B11/6 sensor
The OM656 diesel engine uses an indirect air-water intercooler. The engine control module continuously monitors the intercooler coolant temperature sensor (B11/6). It performs a cross-check after a cold soak, comparing this sensor against ambient (B14), intake air (B17), and engine coolant (B11/4) temperatures. It also relies on a theoretical thermal model while driving.
When the sensor reading deviates from the permitted threshold, generally more than 3 to 5 degrees Celsius, it triggers P00DF28 without forcing the engine into immediate recovery mode. The NTC thermistor inside the sensor can suffer from thermal fatigue over time. This causes micro-fractures in the encapsulation and a shift in its resistance curve.
Ruling out wiring and contact resistance
Before replacing the sensor, the wiring requires inspection. The control module reads temperature via a 5-volt circuit. Micro-oxidation or loose female contacts at the 2-pin connector can introduce parasitic resistance, sometimes ranging from 50 to several hundred ohms.
Even a small addition of resistance on the signal or ground side creates an artificial voltage drop. The control module interprets this as a temperature deviation, logging the same offset code. A drag test on the terminals and a voltage drop test on the sensor ground circuit will confirm if the harness is sound.
Flow and fluid levels in the low temperature circuit
This engine features a separate Low Temperature Circuit (LTC) for the intercooler, complete with its own expansion tank and electric auxiliary pump (M43/6). If the system was not vacuum bled during previous maintenance, trapped air can stagnate around the sensor bulb. This stationary air reads differently than flowing coolant, triggering the offset code.
Similarly, mechanical wear in the electric pump can reduce flow volume without setting an electrical fault. The slower fluid exchange causes the intercooler temperature to rise beyond the expected parameters. The control module detects this mismatch relative to vehicle speed and flags the offset.
Diagnostic starting point
When facing P00DF28 on a GLE with no drivability symptoms, start with a cold-soak temperature comparison. Let the vehicle sit, then use a diagnostic tool to read all temperature sensors before starting the engine. If the B11/6 sensor reads significantly different from ambient and engine coolant temperatures, the sensor itself has likely drifted. If the cold soak values align, activate the auxiliary pump bidirectionally to check for flow and verify the LTC expansion tank level.